Oki B2200 User Manual page 30

P
RINT CARTRIDGE MIS
If the print cartridge (combination of image drum and toner
cartridge) is not located properly this will also cause the error
light to illuminate, and it will usually be impossible to latch the
top cover fully down. (See
T
ONER OR IMAGE DRUM CARTRIDGE INAPPROPRIATE
If you install either a toner cartridge or image drum unit that is
incompatible with your printer, the error LED will flash at
approximately 1-second intervals and the printer will not start.
L
OW TONER CONDITION
If the toner cartridge is out of toner the error LED will flash. In
this case you may be able to resume printing for a small number
of pages by opening and then closing the top cover. Note also
that this condition may be occur even after you have installed a
new toner cartridge if you forget to correctly position the
coloured toner lever when installing the toner cartridge. (See
instruction sheet supplied with new toner cartridge.)
O
THER POSSIBLE ERROR CONDITIONS
If your printer, or the printing preferences on your computer
specify a different paper size or media type than the one you are
using, this may cause an error condition to occur. (See
printing preferences" on page
If an error only occurs when trying to print one particular job, it
may be that the page contains corrupted data, or data that is too
complex for the amount of available printer memory. In this case
try to simplify the page content.
H
ARDWARE FAULT INDICATION
If your printer develops a hardware fault all three status LEDs will
flash fast (flicker approximately four times a second). In this case
you should contact your service representative or your Oki dealer
for advice and support.
-
INSTALLED
"Step 4" on page
16.)
LED indicators > 30
15.)
"Setting