Preset Key - Furuno CH-250 Operator's Manual

7. Press or to select PRESET KEY or SHORT-CUT KEY as desired.
8. Press the [MENU] key twice to register your selection and close the menu.
5.3.2

Preset key

1. Select PRESET KEY following the procedure in paragraph 5.2.1 on page 5-3.
2. Press the [MENU] key to open the menu.
3. Press to select MENU, and then press
MENU
PRESENT
CUSTOM
CUSTOM2
CUSTOM3
ADJUST THE KNOBS AND FUNCTION KEYS TO THE DESIRED SETTING,
THEN PRESS A CUSTOM MODE KEY TO SAVE THE SETTING.
FUNCTION KEY: ENTRY
4. Set the [MODE], [SECTOR], [TRAIN], [RANGE], [TILT] and [FAST SCAN] controls
according to target fish or fishing area.
5. Press the CUSTOM MODE keys [1], [2] or [3] to program. You are asked if you want to save
the settings to the custom key pressed. (In the example, the custom key [1] was pressed.)
SAVE THE SETTING TO CUSTOM1 KEY?
6. Press to select YES.
7. Press the [MENU] key. The message "PRGM SET" appears at the screen top.
8. Press the [MENU] key to finish.
Activating custom mode
1. Press appropriate CUSTOM MODE key. The indication CUSTOM1, CUSTOM2 or
CUSTOM3 appears at the top of the screen depending on key pressed.
2. To escape from the custom mode operation, operate any of the controls among [MODE],
[SECTOR], [TRAIN], [RANGE], [TILT] and [FAST SCAN].
5-6
COM1 COM2
MODE SECTOR
360 °
°
1 240
°
360
°
180
MENU: END
Figure 5-5 PRESET menu
NO YES
: CHANGE MENU: END
or to select PRESET.
HORZ VERT ES PRESET
TRAIN RANGE TILT
0 ° 160 30 °
° °
0 160 30
° °
0 160 30
° °
90 120 90
SYS
SPEED
NORM
FAST
FAST
FAST