Required Equipment
Caution
should be between 1 and 10 megohms (Mohms).
Required Equipment
You need to provide the following equipment:
•
The hub, server, workstation, or PC that you plan to connect to the Ethernet port. The
server, workstation, or PC must have a 10- or 10/100-Mbps network interface card
(NIC).
•
The asynchronous modem or channel service unit/data service unit (CSU/DSU) that you
plan to connect to the serial port.
•
The serial cable that connects the router to the serial device. For information on
selecting and ordering the serial cable, refer to Appendix A, "Selecting a Serial Cable."
•
The terminal or PC with which you plan to configure the software or troubleshoot the
router.
•
If you plan to mount your router on a wall or other vertical surface, two number-six,
3/4-inch (M3.5 x 20 mm) screws. If the wall to which you plan to mount your router is
drywall, you must also provide two hollow wall-anchors (1/8 inch with 5/16-inch drill
bit or M3 with 8-mm drill bit) to secure the screws.
2-4
Cisco 805 Router Hardware Installation Guide
Periodically check the resistance value of the antistatic strap, which