Advertisement
Chapter 11
Change Card Settings
Table 11-2
Heading
SD BER
Provides Sync
Send Do Not
Use
BLSR Ext.
Byte
Admin State
AINS Soak
Type
February 2008
OC-N Card Line Settings (continued)
Description
Sets the signal degrade bit error rate
Indicates that the port has been
provisioned as a network element timing
reference on another node (ONS 15600,
ONS 15454, or ONS 15327)
When checked, sends a DUS (do not use)
message on the S1 byte
Chosen extended byte carries information
that governs BLSR protection switches.
Sets the port service state unless network
conditions prevent the change.
Sets the automatic in-service soak period. Duration of valid input signal, in hh.mm
Defines the port as SONET or SDH.
Enable Sync Msg and Send Do Not Use
must be disabled before the port can be
set to SDH.
NTP-E66 Modify Line and Status Thresholds for Optical Ports
Options
1E-5
•
1E-6
•
1E-7 (default)
•
1E-8
•
1E-9
•
Read-only
•
Yes (checked)
•
No (unchecked)
Yes (checked)
•
No (unchecked; default)
•
•
K3
•
Z2
•
E2
F1
•
IS—Puts the port in-service. The
•
port service state changes to IS-NR.
IS,AINS (default)—Puts the port in
•
automatic in-service. The port
service state changes to
OOS-AU,AINS.
OOS,DSBLD—Removes the port
•
from service and disables it. The port
service state changes to
OOS-MA,DSBLD.
OOS,MT—Removes the port from
•
service for maintenance. The port
service state changes to
OOS-MA,MT.
format, after which the card becomes in
service (IS) automatically (0 to 48 hours,
in 15-minute increments).
SONET (default)
•
SDH
•
Cisco ONS 15600 Procedure Guide, R5.0
11-7
Advertisement
