Advertisement
Chapter 11
Change Card Settings
NTP-E149 Delete Pluggable Port Modules
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Click the Alarms tab:
Step 2
a.
b.
c.
You cannot delete a port on a PPM: if it is in service, part of a protection group, has a communications
Step 3
channel termination in use, is used as a timing source, has circuits, or has overhead circuits. As needed,
complete the following procedures and task:
•
•
•
•
•
•
In node view, double-click the ASAP card where you want to delete PPM settings.
Step 4
Click the Provisioning > Pluggable Port Modules tabs.
Step 5
To delete a PPM and the associated ports:
Step 6
a.
b.
c.
Verify that the PPM provisioning is deleted:
Step 7
•
•
February 2008
This procedure deletes PPM provisioning for SFPs on the ASAP card.
None
NTP-E157 Provision a Multirate PPM, page 11-2
As needed
Onsite or remote
Provisioning or higher
"DLP-E26 Log into CTC" task on page 16-39
Verify that the alarm filter is not turned on. See the
page 17-50
as necessary.
Verify that no unexplained conditions appear on the network. If unexplained conditions appear,
resolve them before continuing. Refer to the Cisco ONS 15600 SONET Troubleshooting Guide.
Complete the
"DLP-E76 Export CTC Data" task on page 16-98
information.
NTP-E61 Modify or Delete Optical 1+1 Port Protection Settings, page 10-4
NTP-E62 Change Node Timing, page 10-4
NTP-E128 Modify or Delete Communications Channel Terminations and Provisionable Patchcords,
page 10-7
NTP-E52 Modify and Delete Circuits, page 9-2
NTP-E134 Modify and Delete Overhead Circuits, page 9-3
DLP-E115 Change the Service State for a Port, page 17-14
Click the PPM line that appears in the Pluggable Port Modules pane. The highlight changes to dark
blue.
Click Delete. The Delete PPM dialog box appears.
Click Yes. The PPM provisioning is removed from the Pluggable Port Modules pane and the
Pluggable Ports pane.
If the PPM was pre-provisioned, CTC shows an empty slot in CTC after it is deleted.
If the SFP or 4PIO is physically present when you delete the PPM provisioning, CTC transitions to
the deleted state, the ports (if any) are deleted, and the PPM is represented as a gray graphic in CTC.
The SFP or 4PIO can be provisioned again in CTC, or the equipment can be removed, in which case
the removal causes the graphic to disappear.
NTP-E149 Delete Pluggable Port Modules
to log into an ONS 15600 on the network.
"DLP-E157 Disable Alarm Filtering" task on
to export alarm and condition
Cisco ONS 15600 Procedure Guide, R5.0
11-5
Advertisement
