Advertisement
NTP-E157 Provision a Multirate PPM
NTP-E157 Provision a Multirate PPM
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Click the Alarms tab:
Step 2
a.
b.
c.
In node view, double-click the ASAP card where you want to provision PPM settings.
Step 3
Click the Provisioning > Pluggable Port Modules tabs.
Step 4
In the Pluggable Port Modules pane, click Create. The Create PPM dialog box appears.
Step 5
In the Create PPM dialog box, complete the following:
Step 6
•
•
Click OK. The newly created port appears on the Pluggable Port Modules pane. The row on the
Step 7
Pluggable Port Modules pane turns light blue and the Actual Equipment Type column lists the equipment
name.
Verify that the PPM appears in the list on the Pluggable Port Modules pane. If it does not, repeat Steps
Step 8
5
through 8.
Repeat the task to provision a second PPM.
Step 9
Click OK.
Step 10
Continue with the
Step 11
line rate.
Stop. You have completed this procedure.
Cisco ONS 15600 Procedure Guide, R5.0
11-2
This procedure provisions a multirate pluggable port modules (PPMs) in
CTC.
None
NTP-E147 Install the ASAP Card, page 2-5
DLP-E211 Install the ASAP 4PIO Modules, page
DLP-E215 Install an SFP, page
Required
Onsite or remote
Provisioning or higher
"DLP-E26 Log into CTC" task on page 16-39
Verify that the alarm filter is not turned on. See the
page 17-50
as necessary.
Verify that no unexplained conditions appear on the network. If unexplained conditions appear,
resolve them before continuing. Refer to the Cisco ONS 15600 SONET Troubleshooting Guide.
Complete the
"DLP-E76 Export CTC Data" task on page 16-98
information.
PPM—Click the slot number where the SFP is installed from the drop-down list.
PPM Type—Click the number of ports supported by your SFP from the drop-down list. If only one
port is supported, PPM (1 port) is the only menu option.
"NTP-E151 Provision an Optical Line Rate" procedure on page 11-3
Chapter 11
18-12, as needed
18-14, as needed
to log into an ONS 15600 on the network.
"DLP-E157 Disable Alarm Filtering" task on
to export alarm and condition
Change Card Settings
to provision the
February 2008
Advertisement
