Advertisement
NTP-E66 Modify Line and Status Thresholds for Optical Ports
Note
Stop. You have completed this procedure.
NTP-E66 Modify Line and Status Thresholds for Optical Ports
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security
Complete the
Step 1
settings. If you are already logged in, continue with Step 2.
Step 2
Complete the
Step 3
On the shelf graphic, double-click the OC-N card that you want to provision. The card view appears.
Click the Provisioning > Line tabs. (Click Provisioning > Optical > Line tabs for the ASAP card).
Step 4
As needed, provision the options in
Step 5
Table 11-2
Heading
Port #
Port Name
SF BER
Cisco ONS 15600 Procedure Guide, R5.0
11-6
If you need to remove the SFP, see the
If you need to remove the 4PIO, see the
page
18-16."
This procedure changes line settings (line type, coding, and length), line
status (in service or out of service), and performance monitoring thresholds
for OC-48, OC-192 cards, and OC-N ports on ASAP cards.
None
NTP-E157 Provision a Multirate PPM, page 11-2
As needed
Onsite or remote
Provisioning or higher
"DLP-E26 Log into CTC" task on page 16-39
"NTP-E69 Back Up the Database" procedure on page
OC-N Card Line Settings
Description
Identifies the port number
Provides the ability to assign the
specified port a name
Sets the signal fail bit error rate
"DLP-E216 Remove an SFP" procedure on page
"DLP-E217 Remove a 4PIO Module" procedure on
at the node where you want to change the
Table 11-2
for each OC-N port.
Options
•
•
•
User-defined; name can be up to 32
alphanumeric/special characters (blank
by default)
•
•
•
Chapter 11
Change Card Settings
14-4.
For an OC-48 card: 1 – 16
For an OC-192 card: 1 – 4
For an ASAP card: up to 16 ports,
denoted by 4PIO module followed by
port number. (Example: 1-3-1
denotes the third port on 4PIO
Module 1.)
1E-3
1E-4 (default)
1E-5
February 2008
18-15.
Advertisement
