Switch Information; Basic Switch Setup - Intel ZT8101 User Manual

Switch Information

The Switch Information screen displays descriptive information about the switch.
From the Main Menu, select Switch Information. This screen contains the following information.
Device Type
MAC Address
Boot PROM Version
Firmware Version
Hardware Version
Device S/N
Name
Location
Contact
Spanning Tree
GVRP
IGMP Snooping
RIP
PIM-DM
DVMRP

Basic Switch Setup

Use the Basic Network Setup menu to set the boot-up operation for obtaining an IP address or to
manually assign the IP address for the switch.
1. From the Main Menu, select Basic Network Setup and press Enter.
2. To configure the IP address, use the Arrow keys or the Tab key to modify the settings in the
New Switch IP Settings column.
Get IP From
IP Address
ZT8101 User's Guide
Field
Specifies the product name: ZT8101 Fast-Ethernet Switch.
Specifies the unique MAC address assigned to the switch. This address is not
configurable.
Specifies the version of the switch's boot code.
Specifies the version of the firmware installed on the switch. You can update this
using a switch utility.
Specifies the hardware version of the main board.
Specifies the serial number of the device.
Specifies the name assigned to the switch system. If you are installing multiple
switches, you should give each a unique name.
Specifies the area or location where the switch resides.
Specifies the contact person for the switch.
Indicates whether STP is enabled or disabled.
Indicates whether the Group VLAN Registration Protocol is enabled or disabled.
Indicates whether the Internet Group Management Protocol Snooping is enabled
or disabled.
Indicates whether the Routing Information Protocol is enabled or disabled.
Indicates whether Protocol Independent Multicast - Dense Mode is enabled or
disabled.
Indicates whether the Distance Vector Multicast Routing Protocol is enabled or
disabled.
Parameter Default
Manual
10.90.90.90
Using the Telnet Console
Description
Description
Specifies the method for assigning the switch an IP address.
Use the spacebar to toggle to Manual, DHCP, or BOOTP.
(For more information about these options, see the
descriptions below.)
Specifies the IP address assigned to the switch. Only
available for the Manual option.
49