Admin, User+ And Normal User Privileges; To Log In Once You Have Created A Registered User; Saving Changes - Intel ZT8101 User Manual

Note: Remeber that APPLY makes changes to the switch configuration for the current session only. All
changes (including user additions or updates) must be entered into non-volatile RAM using the
Save Changes command on the Main Menu, if you want these changes to be permanent.

Admin, User+ and Normal User Privileges

The switch uses two levels of user privileges: Admin and User. Some menu selections available to
users with Admin privileges may not be available to those with User privileges.
The table summarizes the Admin and User privileges:
Switch Configuration Management
Configuration
Network Monitoring
SNMP Community Strings and Trap Stations
Update Firmware and Configuration Files
Switch Utilities
Factory Reset
Reboot Switch
Advanced Setup
User Account Management
Add/Update/Delete User Accounts
View User Accounts

To log in once you have created a registered user

1. From the Login screen, type in your username and press Enter.
2. Type in your password and press Enter.
The main menu screen will be displayed based on your access level or privilege.

Saving Changes

The ZT8101 switch has two levels of memory: normal RAM and non-volatile or NV-RAM.
Configuration changes are made effective by highlighting APPLY and pressing Enter. When you
do this, the settings are immediately applied to the switch software in RAM and immediately take
effect.
Some settings, though, require you to restart the switch before they will take effect. Restarting the
switch erases all settings in RAM and reloads the stored settings from the NV-RAM. Thus, it is
necessary to save all setting changes to NV-RAM before rebooting the switch.
ZT8101 User's Guide
Using the Telnet Console
Admin User
Yes Read Only
Yes Read Only
Yes Read Only
Yes No
Ping; Read Only access
Yes to BOOTP/DHCP Relay
and DNS Relay.
Yes No
Yes No
Yes Read Only
Yes No
Yes No
47