Table of Contents
Advertisement
i Cooling Your Room
1
You must select the Cool mode if you wish to adjust
the:
•
Cooling
temperature
•
Fan speed when cooling
if necessary,
press the
#O(OnlOff)
button.
Result:
•
The air conditioner
starts up in the mode selected
when the unit was last used.
•
The unit beeps.
The air conditioner is fitted with a protection mechanism to
prevent the unit from being damaged when it is started
immediately after being:
• Plugged in
• Stopped
It will start up normally after three minutes.
if the €_ is not displayed at the top of the remote control,
press the _
button on the remote control one or more times until it
appears.
Result:
•
The unit beeps each time you press the _
button.
•
The air conditionerruns inthe Cool mode.
You can change modes at any time.
To adjust the temperature,
press the _
buttons one or more times
until the required temperature
is displayed.
The temperature
can be set between 64°F and 86°F.
Result:
•
Each time you press the _
buttons:
- The temperature
is adjusted
by I°F
- The unit beeps
•
The air conditioner
starts cooling,
if the room temperature
is higher than the selected
temperature.
•
If the room temperature
reaches the set temperature,
the air
conditioner
stops cooling, but the fan is still operating.
Select the fan speed by pressing
the _
button one or more times
until the required setting
is displayed:
_._,
LOW
='_'_= I
Medium
='[_nI I
High
Result:
Each time you press the _
button,
the unit beeps.
5
To control the direction
of the air flow, refer to page 20.
Advertisement
Table of Contents
