Kenmore 41003 Use & Care Manual page 43

Drawers/Crispers (cont.)
To remove and replace a drawer cover:
Ice Bucket (Freezer)
To remove and replace:
Do not use excessive force when removing a drawer
cover. Forced drawer covers can break and/or cause
personal injury.
,
2.
Remove all the drawers as described on page 41.
Slide the drawer cover out until the cover supports
line up with the openings in the side supports as
shown; then carefully remove the drawer cover from
the refrigerator or freezer compartment.
,
,
f
Using both hands, tilt the cover with the right side
raised and position the left side on the desired shelf
support. Lower the right side so the right cover
support lines up with the opening in the side shelf
support.
Slide the cover all the way in to lock it in position.
,
Do not force the ice bucket during removal.
Unnecessary force could cause damage to the
icemaker.
Using both hands as shown, lift the ice bucket up
while slowly pulling it out. Do not force the ice bucket
during removal to prevent possible damage to the
icemaker.
2. Replace the ice bucket by slightly tilting in the top of
the ice bucket and sliding it into place.
43
DA9 c} 0174t3C(EN+ES).inclcl 4'3 2012.6.8 2:13:18 P_[