Turn on projector and source
4
5-10 sec.
source
1
Connect the power cord to the
projector and to an electrical
outlet
The power light
2
Slide open the lens cover
3
Turn on the projector
Touch the power light (or press power on the remote).
The power light will start blinking green.
4
Wait for the lamp to warm up
After a few seconds, the power light will stop blinking
and turn green. It can take a minute for the lamp to
reach full brightness.
Warning: Do not look directly into the lens while
!
the projector is being used.
5
Turn on computer or other source
You may need to press a specific key combination to activate
your laptop's external video port. On most laptops, hold
down the FN key while pressing a key labeled CRT/LCD, LCD/
VGA, a monitor icon
models:
Apple F7
Dell Fn+F8
Fujitsu Fn+F10
Complete laptop activation chart at www.infocus.com/support
Important: If there is still no video, restart your
i
computer (first make sure it's connected to the
projector and the projector is turned on).
6
Change source if needed
If needed, press source (on the projector or remote)
to view the source. You may have to press it more than
once.
on the projector will light amber.
, or similar. Key combos for popular
HP/Compaq Fn+F4 or Fn+F6
IBM ThinkPad Fn+F7
Sony Fn+F7
Toshiba Fn+F5