To Replace The Warmer Drawer; Bearing Glide Placement; Channel Alignment - Kenmore 790.9505 Use & Care Manual

Oven Controls
To replace the warmer drawer:
1. Pull the bearing glides to the front of the outer compart-
ment glide channels until they snap into place (See
Figure 36).
Figure 36: Bearing glide placement
2. Carefully line up both sides of the warmer drawer glide
rails to the outer compartment glide channels located inside
the empty warmer drawer compartment (See Figure 37).
Figure 37: Channel alignment
3. While holding the warmer drawer level and square using
the warmer drawer handle, push (do not force) the warmer
drawer all the way into the outer compartment glide
channels all the way into the range. Open the warmer
drawer again to verify the glides have seated.
4.
If you do not hear the levers "click" or the bearing glides do
not feel seated remove the warmer drawer and repeat
Steps 1 through 3 again. This will minimize possible damage
to the bearing glides.
31