Home Canning; Warmer Zone Control, Turboboil Flex, And Triple Radiant Element - Kenmore 790.9505 Use & Care Manual

Before Setting Surface Controls
Warmer Zone Control, Turboboil Flex, and Triple Radiant
Element
The warmer zone feature located on the center rear area of the
cooktop uses one round outline and is designed to keep food
warm only.
Your range is equipped with the turboboil flex boiling element,
the fastest and most powerful element available on the market
today. The element allows you to bring liquids to a boil in record
time, as well as maintain liquids consistently at a low, warm
simmer.
The triple radiant element (some models) has three element
portions and may be set to heat as 1 (single), 2 (dual), or 3
(triple) element portions together.
LO
OFF
TURBOBOIL FLEX
MED
WARM &
SIMMER
4
OFF
®
TURBO
BOiL
MED
Figure 6: Warmer zone control (L) and Turboboil Flex (R)
TRIPLE ELEMENT
Figure 7:
OFF
DOUBL_
Triple radiant element
LO
Home Canning
Canning can generate large amounts of steam.
Use extreme caution to prevent burns. Always raise the lid to
vent steam away from you. Safe canning requires that harmful
micro-organisms are destroyed and the iars are sealed
completely. When canning in a water bath canner, a gentle but
steady boil must be maintained continuously for the required
time.
Be sure to read and observe all the following points when home
canning with your appliance. Check with the USDA (United
States Department of Agriculture) Web site and be sure to read
all the information they have available as well as follow their
recommendations for home canning procedures.
• Use only quality flat bottom canners when home canning.
Use a straight-edge to check canner bottom.
• Use only a completely flat bottom canner with no ridges
that radiate from the bottom center when home canning.
Heat is spread more evenly when the bottom surface is flat.
Make sure the diameter of the canner does not exceed 1
inch beyond the surface element markings or burner. It is
recommended to use smaller diameter canners on electric
coil and ceramic glass cooktops and to center canners on
the burner grates.
• Start with hot tap water to bring water to boil more quickly.
• Use the highest heat seating when first bringing the water to
a boil. Once boiling is achieved, reduce heat to lowest
possible setting to maintain that boil.
Use tested recipes and follow instructions carefully. Check
with your local Cooperative Agricultural Extension Service
or a manufacturer of glass jars for the latest canning infor-
mation.
• It is best to can small amounts and light loads.
• Do not leave water bath or pressure canners on high heat
for an extended amount of time.
• Alternate surface units between each batch to allow the
units and surrounding surfaces to cool down. Try to avoid
canning on the same burner unit all day.
11