1. Preparation to Remove the Air Conditioner
Slide-Out Chassis
•
Positionthe air conditioner on it's back, Fig° 1
•
Press the indents marked "PUSH" on the bottom
corners of the front grill, this will cause the air
fl!lerto (pop,out) release. Fig, la
•
Grasp the air filler and pulestraight out Fig lb
•
Remove the phillips screw securing the grill front
to the chassis., (from behind where the filter was
removed) Fig Ic
•
To remove the front grill, grasp the lower front
corner (edge) of 1he grill, pulling (gently) outward
and upward, (Flg 4)
•
Repeal the same procedure on the 3 remaining
corners,(sides)
•
Before the front grill can be completely removed
from the cabinet, it will be necessary to
disconnect the (male/tome!e) electrical wire
harness focaled directly behind the front grill
control panel (Fig 5a)
•
Remove the two retaining screws located al the
back of the cabinet securing the slide-out
chassis to the cabinet. (Fig 5)
NOTE:These screws do not have to be
reinstalled once removed, otherwise you wilt
not be_able to remove the slide-out chassis
once the unit is Installed in the window.
-
Remove the phillips screw & retaining brackel
securing the sltde,out-chasslso (lower front
cabinet) Fig,6a
NOTE:This retaining bracket & screw "must"
be reinstalled upon comp=etlon of the window
installation.
(to secure slide-out-chassis to
cabinet)
•
Grasp the pull handle at the front of the slide-out-
chassisend carefully slide the air conditioner out
of the cabinet. (Fig.6)
Please seek assistance for this procedure.
Fig 1
Fig. la
Fig. ! b
Fig- 1 c
FR_IT PANEL
t
_S'"
FIg.2a
Fig, 3
Fig. 4
Fig. 5
Fig. Ba