Download Print this page

Danby Designer DAC12003D Use And Care Manual page 4

Hide thumbs Also See for Designer DAC12003D:

Advertisement

Available languages

Available languages

1. All widng must comply with Iocaf and nationat
electrica! codes and must be installed by a
qualified electrician. If you have any questions
regarding the following Instructions, contact a
qualified electrician.
2. Check available power supply and resolve any
'Mring problems BEFORE Installing and
operating thls unit,,
3. This 1 f5V air conditioner uses 12.0 or less
nameplate amps and may be used in any
properly wired, generai purpose household
receptacle,. See Table t for specifications for
individual branch circuiL
4. For your safety and protection, this unit is
grounded through the power cord plug when
plugged Into into a matching wait outlet,, If
you ere not sure whether your wall outlet Is
properly grounded, please consult a
qualified electrician,
5, The wall outlet (3-pin) must match the plug (3.
pin) on the service cord supplied wilh theunit.
DO NOT use plug adapters. See Table 2 for
receptacle and fuse inlormalion. If it is necessary
to use an extension cord to connect your air
conditioner, use an approved "air conditioner"
extension cord only.(available at most iocal
hardware stores)
6, The rating plate on the unit contains electrical
and other technical data. The rating plate
is located on the right side of the unit, above the
power cord.
b._le1: Suggested individual Branch Circuit
N--am_s----
AWG _re Size
--
5.0to 12
............
14 ....
I AWG- American WireGage
l "Based on copper wire a! 60 °C temperature raling,
Table
2: Receptacle and FuseTypes
RaledVeils
125
Amps
15
Wail Outlel
l_g .[_
FuseSize
!5
Time Delay Fuse
PlugType
(or circuit b reaker)

Advertisement

loading