Water Softener - Danby Designer DDW1805W Instruction Manual

WATER SOFTENER
The hardness of tile water varies from place to place, if hard water is used in the dishwasher, deposits will form on the dishes
and utensils.
The appliance is equipped with a special softener that uses salt specifically designed to eliminate time and minerals from the
water.
Loading the Salt into the Softener
iiiii: 'iii
::! l_.emove the lower basket and unscrew and renaove the cap from the salt container.
if you are filling the container for the first time, fill 2/3 of its votmne with water.
Place the end of the salt fitter(supplied) into the hole and introduce about 2kg of
salt it is normal for a small amount of water to come out of the salt container.
Carefully screw on the cap.
iii ii Jiii
NO TJ_: 1. The salt container must be refilled when the salt warning light comes on. Though the salt container is filled,
the indicator light may not black out before the salt fully dissolves.
2. if there are spills of salt, a soak program could be run to clean the spills.
Adjusting Salt Consumption
........... J
iiiil,2
Unscrew the cap from the salt container.
There is a ring on the container with an arrow on it (see Figure to the side), if
necessary, rotate the ring in the counterclockwise direction fi'om the "-" setting
toward the "+" sign, based on the hardness of the water being used.lt is
recommended that adjustments should be made in accordance with the following
chart:
Clarke Degrees
WA'I ER HARDNESS
°dH
mmol,I
Selector Position
Salt consulnption
(grain,cycle)
Auto l]omy
(cycles/2kgs)
0,-14 0,-10 (),-1.7 0
14,-36 18,-44 1.8,-4.4 / 20 60
36,_71 45,_89 4.5,_8.9 MED 40 40
71 89 8.9 60 25
Contact your local water board for information on the hardness of your water supply.
i
i
11
i: _ i
_2 J
4