Advertisement
General Care & Cleaning
Cleaning
the Cooktop,
Burner
Heads, Caps & Grates
The cooktop
is designed
to make cleaning
easier. Because the gas Burners are sealed, cleanups
are easy when spillovers
are
cleaned
up immediately.
The cooktop,
Burner
Heads
and
Caps
should
be routinely
cleaned.
Keeping
the Burner
Head
Ports dean
will
prevent
improper
ignition
and an uneven
flame.
Refer
to the following
instructions:
THE COOKTOP
IS NOT
REMOVABLE.
Do not attempt
to remove
or lift the cooktop.
J
_Use
caution
when
replacing
the Burner
Caps
so the Electrodes
are not damaged.
This may cause
a delayed
ignition
or prevent
the burner
from
igniting.
_Any
additions,
changes
or conversions
required
in order
for
this appliance
to perform
satisfactorily
must
be made
by Sears
Service.
Call
|=800=4-MY=HOME®
(See back
cover).
Do not remove any ports from the cookfop until they hove completely
cooled and ore sole to hondle.
Do not operote the
surfoce Burners without the Burner Cops ond Burner Heods properly
in ploce.
To Clean
the surface
Burner
Caps ond
Burner
Heods=
Use a soap-filled
scouring
pod
or a mild
cleanser
to clean
the
surface
Burner
Caps.
The ports
(or slots) around
the Burner
Heads
must
be routinely
checked.
If residue
remains
in these
ports
(or slots),
use a small-gauge
wire
or needle
to clean
the slots
or holes.
For proper
flow
of gas and
ignition
of the burner--
DO
NOT
ALLOW
SPILLS,
FOOD,
CLEANING
AGENTS
OR ANY
OTHER
MATERIAL
TO ENTER
THE GAS
OPENING.
ALWAYS
keep
the surface
Burner
Caps
in place
whether
or not the gas
Burners
are in use.
To Cleon
the Burner
Grates=
Be sure burners
and
grotes
ore
cool
before
you
place
your
hand,
a pot holder,
cleaning
cloths
or other
material
on them.
The cast iron burner
grates
can
be washed
in hot soapy
water.
Rinse thoroughly
and dry
the
grates
with
a cloth
- don_t put them
on the cooktop
while
still wet.
Be sure the grates
are positioned
securely
over
the burners.
To remove
burned
on food,
place
the grates
in a covered
container
or plastic
bag.
Add
1/4
cup
ammonia
and
soak
for 30
minutes.
Wash,
rinse
well
and
dry. An abrasive
cleaner
can be used
for
stubborn
stains.
To Cleon the Cooktop and contoured areas of the cookfop- If a spill occurs on the porcelain
cooktop,
blot up spill with an
absorbent
cloth. Rinse with a clean, damp cloth and wipe dry. Do not use harsh abrasive
cleaners
on the cooktop.
They
can scratch the porcelain.
Completely
rinse any mild cleaners
used from the surface
or the porcelain
cooktop
may become
damaged
during
future heating.
DO NOT use spray oven cleaners on the cooktop.
Care and cleaning
of stainless steel (Stainless
steel models
only)
Some models are equipped
with stainless steel exterior
parts. Special
care and cleaning
are required
for maintaining
the
appearance
of stainless parts. Please refer to the table provided
at the beginning
of the General
Care & Cleaning
section in
this Use & Care Guide.
Changing
the Oven
Light
On some models
an interior oven light will turn on automatically
when the oven
door is opened.
The oven light may be turned
on when the door is closed
by
C)
pushing
_
located
on the control
panel.
On some models,
the lamp
is covered
with a glass shield held in place
by a wire holder.
THE GLASS SHIELD MUST BE
IN PLACE WHENEVER
THE OVEN
IS IN USE.
To replace
the light bulb:
CAUTION:
BE SURE THE OVEN
IS COOL.
1.
Turn the power off: at the main source.
2.
Wear
a leather-faced
glove for protection
against
possible
broken
glass.
3.
Replace
bulb with 40-watt
appliance
bulb only.
4.
For models with glass shield,
press holder
on one side to release
glass shield,
change
bulb and be sure to replace
the glass shield.
22
/
Advertisement
