Advertisement
irln-
15
NOW, ATTACH THE DISPOSER DISCHARGE TUBE
TO YOUR SINK'S DRAIN TRAP.
\
First,
check
inside the
disposer
grinding
chain-
ber to remove any objects
or dirt that might
have
dropped in,
Turn the disposer
around to attach the discharge tube.
Some models use a rubber washer that must be assem-
bled to the discharge
tube before
putting the metal
flange over the discharge
tube, see 'D'. Secure metal
flange using the edge tab on the flange and screw. On
other models,
put the rubber washer
in the discharge
tube opening. Slip the metal flange over the discharge
tube. Using the screw(s)
provided, attach the flange to
disposer, see 'E'.
In D. install the discharge
tube gasket onto
the discharge
tube. Gasket must be installed as
shown to assure a leak-proof
installation.
In E
install
discharge
tube
gasket
into
disposer
discharge outlet. Gasket will be held in place by
the discharge
tube flange.
Discharge
F.j
Turn the disposer
so that
the discharge tube lines
up with your drain trap.
Slip the drain trap over the
discharge tube.
I
I
TUBE TOO LONG? Sim-
ply cut off as much as you
need to with a hack saw.
Make
sure you have a
clean, straight cuL
Extension
TUBE TOO SHORT? If the
discharge
tube
doesn't
reach your drain trap outlet,
measure
the
difference.
Then buy a drain extension
tube.
If it fits.
simply tighten the slip
nut on the
trap with a pipe
wrench to make your connec-
tion to
the
discharge
tube
complete,
NOTE: Be sure you comply with
all applicable plumbing codes.
16
DISHWASHER
DRAIN CONNECTION.
NOTE: (If necessary) An approved dishwasher drain connection kit is available from Sears.
Remove the clamp or fittings
from
the end of your
dish-
washer drain hose.
I
Dishwasher__
Slide
large
end
of rubber
coupler, from dishwasher drain
connection
kit, over the inlet
tube of the disposer. Fasten the
coupler to disposer
with the
clamp provided.
plPler
Clamp
nsert one end of the plastic
tube intothe coupler and fasten
with _ inch clamp.
DrainHose
Slip the remaining clamp (the
one you pruchased) over the
dishwasher
drain
hose
and
back two or three inches. No_
slip the drain hose over
the
plastic tube, slidethe clamp into
place and tighten.
NOTE: Check the three clamps to be sure you have tightened all of them.
Advertisement
