Dishwasher Connection - Kenmore 587.70413 Use & Care Manual

Dishwasher Connection

If you are utilizing a dishwasher, complete the following procedure. If dishwasher is
not to be connected go to section Installation of Mounting Assembly.
A. Using a blunt instrument (steel punch or wooden dowl), knock out entire plug (see
A). Do not use a screwdriver or sharp instrument. When knockout plug falls into
disposer, you may remove it or simply grind it up when the disposer is used. This
will not damage the disposer in any way, but may take some time to grind over
the course of several uses. Go to section Installation of Mounting Assembly.
B. Connect dishwasher hose using hose clamp. If hose size is different, you will need
a Dishwasher Connector Kit (see B). Make sure all plumbing connections are tight
and in accordance with all plumbing codes and ordinances. Run water and check
for leaks.
Mounting Assembly
1
Stopper
2
Sink Flange
3
Fiber Gasket
Backup Flange
4
5
Mounting Ring
6
Screws
7
Snap Ring
Hush Cushion
8
9
Lower Mounting Ring
NOTE: Hush Cushion is included between mounting ring and lower mounting ring.
*AIR GAP
A
KNOCK
DISPOSER
OUT PLUG
*Air gap may not be required
for all installations. Check local
plumbing codes.
PLUMBER'S
PUTTY
PLUMBER'S
PUTTY
RESET BUTTON
* Batch Feed Stopper looks different than the stopper illustrated.
** Mount Assembly
5
B
DISHWASHER
HOSE
RUBBER
HOSE
SINK
SINK
A
SINK FLANGE**
STOPPER*
RIDGE
SINK FLANGE**
FIBER GASKET
RIDGE
BACKUP FLANGE
FIBER GASKET
SCREWS
BACKUP FLANGE
MOUNTING RING
MOUNTING RING
SNAP RING
SNAP RING
LOWER
MOUNTING
RING
HUSH
CUSHION
®
RUBBER
GASKET
** Mount Assembly