NEC MH4000 User Manual page 131

C
12. Set any device jumpers or switches on the device.
13. Using the four screws supplied with the drive,
14. Engage the device side rails into the bay guide rails
15. Push the drive into the bay until the screw holes of
Figure 5-20. Removing Side Rails
A
Refer to the installation procedures that came with
the device.
Notice: SCSI termination resistors for the 5 1/4-inch
devices must be installed in the last SCSI device of the
daisy chain cabling (top media bay A). All other 5 1/4-
inch devices must have terminators removed.
reinstall the side rails just removed from the blank
panel tray (Figure 5-21, A). Attach the rails to each
side of the device (C) by using only the bottom screw
holes, as shown. The rails for each side of the device
are identical.
(see Figure 5-22). Ensure that the device side rails
(see Figure 5-22, A) are inside the bay guide rails
exactly as shown in Figure 5-22, B.
the side rails are directly in front of the chassis
screw holes and secure with the screws previously
removed (see Figure 5-21, C).
Removing side rails from
blank panel tray
A Screws
B Side rails
C Blank panel tray
B
Upgrades and Options
5-47