Limitations; Restrictions - NEC Express5800/320Lb FT Linux Release Note

Partition Check:
sdg:<6> I/O error: dev **:**, Command ********, sector 0
I/O error : dev **:**, Command ********, sector 0
unable to read partition table

Limitations

The following limitations apply to the Express5800/320Lb FT Linux.
limitations below carefully to ensure that they are followed.
System Hardware
320Lb systems purchased with or previously running the Windows Operating
System cannot be loaded with the FT Linux Operating System. The following
conditions may occur:
The system may hang after a PCI Module breaks and is restoring to service.
The root cause is due to insufficient decay of 3.3V during a 1 second power-off
cycle during the PCI module bring-up after a failure. This condition has been
corrected for new 320Lb systems purchased with the Windows Operating
System after mid-November 2004.
Memory Limit
The FT Linux OS currently have a 3GB (6x512MB) memory upper limit.

Restrictions

The following limitations apply to the Express5800/320Lb FT Linux.
restrictions below carefully to ensure that they are followed.
List of Restrictions
1
LAN card that is not connected to the network
If LAN cards connected to the device are not used (i.e. cables are not connected),
the ports on those cards are recognized as BROKEN state, turning the status color
of data viewer ([FtServer]-[PCIModule]-[Ethernet board]) as well as Operation
Window to red (abnormal). Connect those LAN cards together using the LAN
cables (cross cable) to avoid this status.
Note:
This limitation does not apply on any
systems ordered and preloaded with FT Linux at the
factory.
Restrictions
Express5800/320Lb System Release Notes 5
Please read the
Please read the