First Steps (Installation); To Turn The Receiver On Or Off; Operating The On-Screen Display (Osd); First-Time Installation - Philips PFS0001 User Manual

SAT HDTV Module

First Steps (Installation)

To turn the receiver on or off

1. Turn on the TV set the receiver is connected to.
2. Press HOME to open the Home menu and select the icon you chose for the
satellite receiver and press OK.
3. When you switch the TV in Standby, the satellite receiver will switch of in Standby
a few seconds later.
4. When you switch the TV in Standby while the satellite receiver was on screen, the
satellite receiver will come back on when you switch the TV on again.
No need to switch to the receiver in the Home menu.

Operating the on-screen display (OSD)

The on-screen menu (referred to as on-screen display = OSD) lets you change
the TV settings via the remote control.
Note: Also read the info and help texts shown on the screen.
This is how you use the on-screen display functionality:
To navigate the OSD or to select menu items press the
your remote control as appropriate. Selected items will be highlighted.
To confirm a selection press OK. The selected menu item is now run or exe-
cuted.
To hide the OSD or to quit a menu press BACK.
The red, the green, the yellow and the blue colour buttons on the remote con-
trol have various functions assigned to them which depend on the menu cur-
rently on the screen.
Go by the colour of the OSD icons: a red, green, yellow or blue icon is control-
led by remote control button of that colour.
At the bottom edge of every OSD screen, you will see notes as to which con-
trols you must press to make any settings using the current menu.

First-time installation

When you turn on the receiver for the first time you will see the First-Time Instal-
lation page.
1. Press OK to confirm.
The First Time Installation page is displayed.
60

arrows on