Important Notes About Steam Cycles - Kenmore 796.8219 Series Use & Care Manual And Installation Instructions

STEAM FUNCTIONS
To Fill the Steam Feeder
O Pull out the drawer.
O Lift out the steam feeder.
O Fill the steam feeder to MAX line with water.
Tap water
Steam ONLY
Feeder
_. 2 J
@ Place the steam feeder in the drawer; then push in the
drawer until it clicks into place.
IMPORTANT NOTES ABOUT STEAM CYCLES
Add
Water
Before using a Steam Cycle, the steam feeder must be filled with water up to the MAX line.
If not, the ADD WATER light will blink. Make sure that the steam feeder is filled with water
and the drawer is completely closed. Turn the dryer off then restart the Steam Cycle. When
steam is used for the first time, it is possible that the steam feeder may not have enough
water and the ADD WATER light will come one. Refill the feeder and restart the cycle.
Timed Dry
.............................
• Only use water. Do not fill the steam feeder with foreign substances, rinse agents, or detergents.
• Before moving the dryer, make sure the steam feeder is empty.
• Do not use distilled water; the water level sensor in the steam generator will not work.
• Be careful to put the Steam Feeder otherwise water will be overflow.
• Wipe up any spilled water around the Steam Feeder and the drawer before starting the dryer.
WARNING
• Do not fill the steam feeder with liquids such as gasoline, dry-cleaning solvents, or other flammable or explosive sub
stances. They give off vapors that could explode.
• Do not fill the steam feeder with hot water (over 86°F/30°C).
• Do not drink water from the steam feeder.
• During steam operation, the clothes will be tumbled only for a few seconds once a minute.
26