Download Print this page

Important Notes About Steam Cycles - Kenmore 796.6152 Series Use & Care Manual

Sears
Hide thumbs

Advertisement

Table of Contents
_t
Putt out the drawer.
Steam
Feeder
Water
ONLY
_t
Fill the steam feeder with ordinary
tap water to the
MAX line or until the water touches the filter screen.
O
Lift out the steam feeder.
_!
Place the steam feeder in the drawer; then push in
the drawer until it clicks into place.
IMPORTANT
NOTES ABOUT
STEAM CYCLES
Before using a steam cycle, the steam feeder
must be filled with water up to the MAX llne; make sure that the
drawer is completely closed. If the steam feeder
runs out of water, the ADD WATER light will blink. If the light
blinks, turn the dryer off, refill the feeder, and then restart the steam cycle.
When steam is used for the first time, it is possible that the steam feeder
may not have enough water and the ADD
WATER light will illuminate.
Refill the feeder and restart the cycle.
*Only use water. Do not fill the steam feeder with other liquids, rinse agents, or detergents.
*Before moving the dryer, make sure that the steam feeder
is empty.
"Do not use distilled water; the water level sensor in the steam generator
will not work.
"Be careful not to spill water when filling and replacing
the steam feeder.
*Wipe up any spilled water around the steam feeder and drawer before starting the dryer.
"During
steam operation,
the clothes will tumble for only a few seconds, once a minute.
WARNING:
* Do not fill the steam feeder with liquids such as gasoline, dry-cleaning
solvents, or other flammable
or explosive
substances. They give off vapors that could explode.
"Do not fill the steam feeder with hot water (over 86°F/30°C).
"Do not drink water from the steam feeder.
27

Advertisement

Table of Contents
loading

This manual is also suitable for:

796.7152 series