Other 3/3 Screen - Panasonic AW-HE120KE Operating Instructions Manual

Setting the camera menu items
Max Digital Zoom
[x2, x3, x4, x5, x6, x7, x8, x9, x10]
The upper limit for the digital zoom magnification is set
here.
Tally Enable [Disable, Enable]
"Enable" or "Disable" is set here for the function which
turns on or turns off the tally lamp using the tally control
signal.
Wireless Control [Disable, Enable]
"Enable" or "Disable" is set here for operations conducted
from the wireless remote control.
The operations are enabled when the unit's power is
turned on from an external device other than a wireless
remote control, and they are disabled when the power is
turned on from a wireless remote control.
Notes
  At the point when this item's setting is changed, the
new setting is not reflected in operation.
It is reflected when the unit is set to the standby
mode and its power is turned on.
  Follow one of the procedures below if the item's
setting is changed by mistake and the unit can no
longer be operated from a wireless remote control.
When menu operations can be performed using
another control device:
 First change the item using a control device
capable of performing menu operations, and
then turn off the unit's power and turn it back
on.
When menu operations cannot be performed
using other control devices:
1. Turn off the power of the units and devices
that are connected.
2. Disconnect the unit's power cable, and plug it
back in.
3. Perform the operation for turning on the unit's
power from the wireless remote control.
4. After changing this item, turn off the unit's
power and turn it back on.
Return
Use this to return to the previous menu.
50
(continued)
 Other 3/3 screen 
O t h e r 3 / 3
O S D M i x
S D I O u t
H D M I O u t
C o m p o n e n t O u t
V i d e o O u t
O S D O f f W i t h T a l l y
O S D S t a t u s
R e t u r n
OSD Mix
Whether the camera menus, statuses and other displays
are to be turned Off or On can be selected here for each
output picture.
SDI Out [Off, On]
HDMI Out [Off, On]
Component Out [Off, On]
Video Out [Off, On]
Off: The camera menus and statuses are not displayed
on the output pictures targeted by the setting items
listed above.
On: The camera menus and statuses are displayed for
the output pictures covered by the setting items listed
above.
OSD Off With Tally [Off, On]
This is used to enable or disable the function for clearing
the camera menu and status displays when the tally signal
is received by a command or contact.
When the tally signal is released, the original camera
menu displays are restored.
OSD Status [Off, On]
"On" or "Off" is set here for the status display which
appears during AWB operations.
Return
Use this to return to the previous menu.
O n
O n
O n
O n
O f f
O f f