Panasonic AW-HE120KE Operating Instructions Manual page 21

Preset memories
When the AW-RP555 is connected:
Up to 10 settings can be registered and called.
The [1] to [10] buttons of [PRESET] correspond to the unit's
preset memories No.1 to No.10.
 Registering the settings in the preset memories 
1
Display the picture to be shot on the monitor.
Operate the [PAN/TILT] lever and [ZOOM] lever to
determine the camera angle.
Adjust the focus, iris, gain and white balance if they need
to be adjusted.
2
Hold down the [MEMORY] button.
The buttons among the [1] to [10] buttons of [PRESET]
in which settings can be registered now start blinking in
sequence.
3
With the [MEMORY] button still held down,
press the button of the preset memory number
in which the setting is to be registered.
 Calling the settings of the preset memories 
1
Press the button among the [1] to [10] buttons
of [PRESET] in which the desired setting was
registered.
 Erasing preset memory settings 
1
While holding down the [MEMORY] button,
press the [OP] button.
The [OP] button lamp blinks, and the standby status is
established.
2
Press the [OP] button to establish the setting
mode.
The [PRESET] [1] to [10] button lamps blink in sequence.
When the [ZOOM] lever, [PAN/TILT] lever or [FOCUS]
lever is now operated, the mode is forcibly exited.
3
Press the [PRESET] button corresponding to
the preset memory which is to be deleted.
(continued)
When the AW-RP50 is connected:
Up to 100 settings can be registered and called.
For details, refer to the Operating Instructions of the
controller.
21