Fisher & Paykel EB60DSXB Installation Instructions And User Manual page 18

Using the appliance for the fi rst time
16
EN
Replacing the filter ("FILTER RESET")
When "REPLACE FILTER" is displayed or after 2 months of use (see date indicator), the filter must
be replaced:
Remove the exhausted filter;
1
Remove the new filter from the packaging.
2
Slide the pointer of the date indicator (see fig. 29) until the months of use are displayed (the filter
3
lasts about 2 months);
Insert the filter in the water tank and press it until it touches the bottom of the tank (see fig. 29);
4
Fill the water tank and insert in the coffee maker;
5
Turn the cappuccino maker outwards and place a container underneath (min. capacity 100 ml).
6
Press the icon (B2) to enter the menu;
7
Press the icons (B7) and (B8) until "FILTER RESET" is displayed;
8
Press the OK icon (B9);
9
The message "FILTER RESET CONFIRM" is displayed.
10
Press the OK icon (B9) to confirm the selection (or ESC (B6) to cancel). "HOT WATER PRESS OK" is
11
displayed.
Press the OK icon (B9) again. The appliance begins delivering hot water and the message
12
"PLEASE WAIT... " is displayed. When delivery stops, the appliance automatically displays the basic
modes set again.
Removing the filter
To use the appliance without a filter, you must remove it and notify the appliance of its removal
as follows:
Press the icon (B2) to enter the menu;
1
Press the
2
Press the OK icon (B9);
3
The message "INSTALL FILTER* CONFIRM" is displayed.
4
Press the ESC icon (B6).
5
When the asterisk has disappeared from the top right of the display, press ESC (B6) to exit the
6
menu.
Note: Use the filters recommended by the manufacturer only. Use of unsuitable filters could
damage the appliance.
icons (B7) and (B8) until "INSTALL FILTER" is displayed;