Fisher & Paykel EB60DSXB Installation Instructions And User Manual page 17

Installing the filter
Some models are fitted with a water softener filter to improve the quality of the water used and
extend the working life of the appliance.
To install, proceed as follows:
Remove the filter from the packaging;
1
Slide the date indicator pointer (see fig. 29) until the months of use are displayed.
2
Note: The filter lasts about two months if the appliance is used normally. If the coffee maker is
left unused with the filter installed, it will last a maximum of three weeks.
Fill the tank with a little water up to the level shown:
3
Insert the filter in the water tank and press it until it touches
4
the bottom of the tank (see fig. 29);
Fill the water tank and insert in the coffee maker;
5
Place a container underneath the cappuccino maker
6
(min. capacity: 100 ml).
Press the icon (B2) to enter the menu;
7
Press the icons (B7) and (B8) until "INSTALL FILTER" is displayed;
8
Press the OK icon (B9);
9
The message "INSTALL FILTER PLEASE CONFIRM" is displayed.
10
Press the OK ICON (B9) to confirm the selection (or ESC (B6) to cancel). "HOT WATER PRESS OK" is
11
displayed.
Press the OK icon (B9) again. The appliance begins delivering hot water and the message
12
"PLEASE WAIT... " is displayed. When delivery stops, the appliance automatically displays the basic
modes set again.
Note: The appliance may request the operation to be repeated a number of times until the air is
completely eliminated from the hydraulic circuit.
Using the appliance for the fi rst time
15
EN