Table of Contents
Advertisement
5
Connectors
5.1 Ethernet connector (X1)
This is the Ethernet jack for connecting the ADA-16FX-ETHERNET to the Ethernet. The
connector complies with the 10BaseT standard. The used connector has integrated
transformers for transmit and receive lines.
The Ethernet jack and the Ethernet controller depends on the power supply voltage:
Supply Voltage
Used jack
Halo HFJ11-
5V
Halo HFJ11-
3V3
5.2 Edge Connectors (X2, X3, X11)
The edge connectors are assembled on the bottom side of the adapter board. They are used
to attach the ADA-16FX-ETHERNET adapter board to the SK-16FX-EUROSCOPE (SK-
16FX-100PMC) evaluation board. All used signals are provided by the edge connectors.
Connector
X2 (1 – 20)
X3 (71 – 100)
X11 (51 – 70)
The adapter board is powered via the edge connectors.
UG-960011-10
ADA-16FX-ETHERNET
Chapter 5 Connectors
Ethernet Chip
CS8900CQZ
1043E
CS8900CQ3Z
1041E
MCU Pins
1 – 20
71 – 100
51 – 70
- 10 -
Adapter Board
Transitions
ADA-16FX-
ETHERNET
-
© Fujitsu Microelectronics Europe GmbH
Rx
Tx
Transitions
1:1
1:1.41
1:1
1:2.5
Advertisement
Table of Contents
