Table of Contents
Advertisement
About the ceramic glass cooktop
The ceramic cooktop has radiant surface elements located
below the surface of the glass. The design of the ceramic
cooktop outlines the area of the surface element
underneath. Be sure to match the pan size with the
diameter of the element outline on the cooktop and only
flat-bottomed cookware should be used.
The type and size of cookware, the number of surface
elements in use and their settings are all factors that will
affect the amount of heat that will spread to areas beyond
the surface elements. The areas surrounding the elements
may become hot enough to cause burns.
About the radiant surface elements
The element temperature rises gradually and evenly. As the
temperature rises, the element will glow red. To maintain
the selected setting the element will cycle ON and OFF. The
heating element retains enough heat to provide a uniform
and consistent heat during the off cycle.
For efficient cooking, turn OFF the element several minutes
before cooking is complete. This will allow residual heat to
complete the cooking process.
Types of cooktop elements
The ceramic glass cooktop has radiant surface elements
located below the surface of the glass. The patterns on the
ceramic glass will outline the size and type of element
available. The single radiant element will have one round
outline pattern shown (keep warm zone is designed to
keep food warm only). The dual radiant element is flexible
because you may set just the smaller inner portion as a
single element or both inner and outer portions can be set
to heat together (See Fig. 1).
Keep warm zone
Single radiant
surface control
surface control
(some models)
Dual radiant
surface control
(some models)
Fig. 1
BEFORE SETTING SURFACE CONTROLS
Element ON & hot surface indicator lights
Your appliance is equipped with two different types of
radiant surface control indicator lights that will glow on the
backguard — the Element On indicator light and the Hot
Surface indicator lights (See Fig. 2).
The Element ON indicator lights are located on the
control panel above each radiant element control knob and
will glow when a surface element is turned ON. A quick
glance at this indicator light after cooking is an easy check
to be sure ALL surface controls are turned OFF. The Hot
Surface indicator light located on the control panel will
glow when any surface cooking area heats up and will
remain on until the glass cooktop has cooled to a
MODERATE level.
NOTES
• Radiant elements have a limiter that allows the surface
element to cycle ON and OFF, even at the HI setting.
This helps to prevent damage to the ceramic
smoothtop. Cycling at the HI setting is normal and will
occur more often if the cookware is too small for the
radiant element or if the cookware bottom is not flat.
• Be sure to read the detailed instructions for ceramic
glass cooktop cleaning in the Care & Cleaning and
Before You Call checklist sections of this Use & Care
Manual.
element ON
indicator
light
Fig. 2
hot
surface
indicator
light
7
Advertisement
Table of Contents
