Table of Contents
Advertisement
Air circulation in the oven
For best baking results allow 2-4" (5-10 cm) around the
cookware for proper air circulation and be sure pans and
cookware do not touch each other, the oven door, sides or
back of the oven cavity. Hot air must be able to circulate
around the pans and cookware in the oven for even heat
to reach around the food.
Baking layer cakes with 1 or 2 oven racks
For best results when baking cakes using 2 oven racks,
place cookware on rack positions 3 & 5 (See Fig. 1). For
best results when using a single oven flat rack, place
cookware on rack positions 3 or 4 (See Fig. 2).
Fig. 1
About the ceramic glass cooktop
The ceramic cooktop has radiant surface elements
located below the surface of the glass. The design of the
ceramic cooktop outlines the area of the surface element
underneath. Be sure to match the pan size with the
diameter of the element outline on the cooktop and only
flat-bottomed cookware should be used.
The type and size of cookware, the number of surface
elements in use and their settings are all factors that will
affect the amount of heat that will spread to areas beyond
the surface elements. The areas surrounding the elements
may become hot enough to cause burns.
About the radiant surface elements
The element temperature rises gradually and evenly.
As the temperature rises, the element will glow red. To
maintain the selected setting the element will cycle ON
and OFF. The heating element retains enough heat to
provide a uniform and consistent heat during the off cycle.
For efficient cooking, turn OFF the element several
minutes before cooking is complete. This will allow residual
heat to complete the cooking process.
All manuals and user guides at all-guides.com
BEFORE SETTING SURFACE CONTROLS
Element ON & hot surface indicator lights
Your appliance is equipped with two different types of
radiant surface control indicator lights that will glow on the
backguard — the Element On indicator light and the Hot
Surface indicator lights (See Fig. 3).
The Element ON indicator lights are located on the
control panel above each radiant element control knob
and will glow when a surface element is turned ON. A
quick glance at this indicator light after cooking is an easy
check to be sure ALL surface controls are turned OFF. The
Hot Surface indicator light located on the control panel
will glow when any surface cooking area heats up and
will remain on until the glass cooktop has cooled to a
MODERATE level.
Fig. 2
element ON
indicator
light
NOTES
Radiant elements have a limiter that allows the element
to cycle ON and OFF, even at the HI setting. This helps
to prevent damage to the ceramic smoothtop. Cycling
at the HI setting is normal and will occur more often if
the cookware is too small for the radiant element or if
the cookware bottom is not flat.
Be sure to read the detailed instructions for ceramic
glass cooktop cleaning in the General Care &
Cleaning and Before You Call checklist sections of
this Use & Care Manual.
hot surface
indicator
Fig. 3
light
9
Advertisement
Table of Contents
