Appendix G: Long Landing Monitor Maintenance Messages - Honeywell MK V Line Maintenance Manual

17 APPENDIX G: LONG LANDING MONITOR MAINTENANCE MESSAGES

MAINT.
FUNCTION
Except where noted, all maintenance
message voices are Male
Self-Test Level 1 "Runway Awareness Inhibited" (only if RAAS
enabled at same time as Long Landing Monitor)
Self-Test Level 3 "Long Landing Enabled"
(Annunciated at
end of Selected
Options )
Self-Test Level 3 "RCD Part Number XXX-XXXX-XXX "
where X is the 10-digit installation-specific RCD
part number.
NOTE: Operators/Installers must refer to their Instructions for Continued Airworthiness (ICA) documentation to
identify the approved RCD configurations specific to their aircraft type/model having Long Landing Monitor
installed.
CAGE CODE: 97896
EGPWS LINE MAINTENANCE MANUAL
TABLE G-1: LONG LANDING MONITOR MAINTENANCE MESSAGES
MESSAGE
SCALE: NONE SIZE: A
All volume levels at same volume as
existing EGPWS Self-Test messages
Long Landing Monitor enabled, but the
advisories have been inhibited with the
activation of an external input/switch. NOTE –
the EGPWS does not support a dedicated Long
Landing Monitor inhibit, but activation of a
defined RAAS inhibit will also inhibit Long
Landing Monitor.
RCD Enable Key is set and loaded RCD
activates Long Landing Monitor function.
Allows verification that the correct RCD is
loaded into the EGPWS.
DWG NO.: 060-4199-180
NOTES:
REV: G SHEET 67 of 68