Advertisement
E does not produce any appreciable heat under
standard use. The Elite-16 PF E may also be
rack mounted in a standard 19" (48.26 cm) rack
by attaching the Elite-16 PF E rack ears. These
rack ears (contained within the plastic rack kit
package) mount flush with the back portion
of the Elite-16 PF E's front panel. They are
attached to the chassis by installing each rack
ear with () pan-head Philips screws contained
within the Elite-16 PF E rack mounting kit. The
third screw used for each rack ear is for the
center hole, located towards the rear and aids
in stabilizing the unit when rack mounted.
c
onnectIon
ac c
r
able
outIng
Once the Elite-16 PF E is placed, its AC cord's
female end must be plugged into the male
IEC connector located on the lower left hand
side of the rear panel (when facing the rear
panel). Next the male plug must be connected
to an appropriate socket (see current rating
recommendation above).
c
c
onnectIng
omponents to the
F
V
c
Iltered
Ideo
omponent
The Elite-16 PF E's four "Linearly Filtered Video
AC Outlets" should be employed for critical
video and or digital components such as DVD
players, projectors, plasma, or LCD screens.
When employing the Elite-16 PF E for a -
channel audio system, an SACD player would
be ideally suited for one of these outlets.
c
c
onnectIng
omponents to the
a
c
ac o
udIo
omponent
The Elite-16 PF E's four "Linear Filtered Audio AC
Outlets" should be employed for any component
not connected to the "Linearly Filtered Video
AC Outlets," with the exception of receivers,
l
Inearly
ac o
b
utlet
anks
l
F
Inear
Iltered
b
utlet
anks
Elite-16 PF E Manual
power amplifiers and powered sub-woofers.
These outlets possess the same exceptional AC
noise filtering and isolation to maximize system
performance.
c
c
onnectIng
omponents to the
p
a
b
oWer
mplIFIer
anks
All power amplifiers, receivers and powered
sub-woofers should be connected to these four
outlets.
Many Audiophile and premium Home Theater
systems will have combined continuous current
demands well below 16 Amps. It is rare, in fact,
for large power amplifiers to draw more than 3
Amps continuously. For superior performance,
it is vital that an AC filter possess extraordinarily
low impedance, and have the capability to pass
peak current demands far in excess of the RMS
(continuous) current rating.
The Elite-16 PF E was designed to more than
meet this demand.
Correction Circuitry effectively creates a current
reserve in excess of 45 amps peak charge that
is cleaner and far more efficient when supplying
needed current to your power amplifier than a
dedicated line from your local power station.
This feature eliminates any concern towards
the current compression that can result from
typical power conditioners, and the peak
power reservoir benefits any power amplifiers
performance dramatically.
n
p
F
ote about
oWer
actor
c
c
urrent
onsumptIon
When power correction technology is employed
with even the most sophisticated circuit breakers,
it effectively adds to the perceived current load.
Though the Elite-16 PF E was designed for
steady 16 Amp operation, and peak current
demands many times that, the maximum total
h
c
Igh
urrent
Additionally, our Power
c
orrectIon and
- -
Advertisement
