Ipod; Indication For Cd Player; Indication For Usb Memory - Alpine CDE-W235BT Owner's Manual

iPod

iPod does not play and no sound is output.
• The iPod has not been recognised.
– Reset this unit and the iPod. Refer to "Initial System Start-Up" on
page 9. To reset the iPod, refer to the Owner's Manual of the iPod.

Indication for CD Player

• No CD is inserted.
– Insert a CD.
• Although a disc is inserted, "NO DISC" is displayed and the unit does
not start to play or eject the disc.
– Remove the disc by following these steps:
Press the  button again for at least 2 seconds.
If the disc still does not eject, consult your Alpine dealer.
• Mechanism error.
1 Press the  button and eject the CD.
If not ejecting, consult your Alpine dealer.
2 When the error indication remains after ejecting, press the 
button again.
If the error indication still does not turn off after pressing the 
button for a few times, consult your Alpine dealer.
• When "ERROR" is displayed:
If the disc cannot be ejected by pressing , press the RESET button
(Refer to "Initial System Start-Up" on page 9) and press  again.
If the disc still cannot be ejected, consult your Alpine dealer.
(CDE-W235BT only)
• A copy-protected WMA file was played back.
– You can only play back non-copy-protected files.
• A sampling rate/bit rate not supported by the unit is used.
– Use a sampling rate/bit rate that is supported by the unit.

Indication for USB Memory

• A USB device that is not supported by the unit is connected.
– Connect a USB device that is supported by the unit.
NO DEVICE
• A USB Memory is not connected.
– Make sure the USB Memory device is correctly connected and the
cable is not excessively bent.
• No song (file) is stored in the USB Memory.
– Connect the USB Memory device after storing songs (files).
(CDE-W235BT only)
• A copy-protected WMA file was played back.
– You can only play back non-copy-protected files.
• A sampling rate/bit rate not supported by the unit is used.
– Use a sampling rate/bit rate that is supported by the unit.
NO SUPPORT
• Text information that is not recognizable by the unit has been input.
– Use a USB Memory device with input text information that is
supported by the unit.
• Communication error
– Turn the ignition key off, and then set to ON again.
– Check the display by reconnecting between the USB Memory and
this unit.
• Power surge error
Excessive voltage/current is supplied to the USB Memory.
– Try another USB Memory, if available.
37
-EN