Before You Call For Service - Danby DHCC6020 Owner's Manual

BeforeYouCall ForService
Problem PossibleCause
No power. A fuse in your home may
be blown or the circuit
breaker tripped.
Powersurge.
Plug not inserted
fully into outlet.
What to do
Replace fuse or reset circuit breaker,
Will not start in Humidity Level
Dehumidifier mode settee high
Unplug the unit, wait a few seconds
and then plug it beck in.
Will not start in Humidity Level
Humidifier mode set too low
Make sure the 3-prong p ug on the
DHCC is fully inserted into the cutter
Verify the current detected Humidity
level as shown in the Ambient
Temperature!Humidity display area
and adjust your settings accordingly.
Vedfy the current detected Humidity
level as shown in the Ambient
Temperature/Humidity display area
and adjust your settings accordingly.
Wi]I not start _n Front grill net installed Ensure the front grill is correctly
Air Purification mode COrrectly. installed on the chassis,
Low airflow from top HEPA filter requires Refer to page # for details on how
grill during Air Purifier replacement to replace the HEPA tilter
mode.
Incorrect HEPA filter Replace HEPA filter only the filter
that was designed for your DHCC.
Low airflow from side Air filter requires Refer to page # for instructions an
grill during Dehumidifier cleaning cleaning the air filter
mode
El, E2, E3 Sensor Error Contact an authorized Danby service
center.
154 Water bucket not installed Reinstall Water Bucket,
E5 Internal Reservoir Full During Dehumidification: Empty the
Water Bucket and reinstall.
During Humidification: Partiafy
empty the Water Bucket and reinstall.
Empty Water Bucket.
E6
E7
Water Bucket Full
Front Cover off. Replace front cover and/or ensure it
is installed correctly,
If none of the above rectify the situation please contact our customer service depart-
ment at 1-800-26-_1 r (%800-263-2629)
13