Danby DHCC6020 Owner's Manual page 11

The operating mode can be defined when the unit is 'On' or
in 'Standby'. The following steps are provided assumfng the
unit is in standby mode.
1) Open the upper rear panel and locate the internal reser-
voir fill cap. Proceed to remove the fill cap (fig E.) from the
reservoir,
2) Slowly fill the internal water reservoir with fresh clean
wafer until the Wafer Level Display illuminates all _our status
bars to signify the tank is full (as shown in Fig G).
3) Replace the fill cap and close the upper rear panel. If you
have removed the wafer tank during the fill process ensure
fhat the handle on the internal reservoir has been returned
to it's origina_ position - flat against the bucket.
4) Depress the 'Mode' button on the control panel until the
Humidifier icon is displayed in the LCD screen (Fig H).
5) Select the desired humidity level from 35% RH ~ 80% RH
by depressing either the increase (,i.) or decrease ("IF)but-
tons on the control panel. To select continuous as the mode
of operation in lieu of defining a precise humidity level, press
the increase or decrease button )anti] see the" - -" in the
set humidity display portion of the LCD, as shown in Fig. L
6) Depress the powerbutton to start the unit in Humidifier
mode at your specified settings.
Rease note: During fhe Humidifier mode, the fan speed
cannot be changed.
10