Direct Drain Operation - Danby DHCC6020 Owner's Manual

The operating mode can be defined before the unit is
Switched "On' by depressing the "Mode' button (ensure
the power cord is connected), and defining the desired
operating mode while the control panel remains illumi-
nated (approximately 5 seconds).
1) In high humidity conditions, in order to extend the period
of uninterrupted usa, ensure that the internal bucket is
empty (Fig A) before starting the dehumidifying mode.
2) Depress the 'Mode' button on the control panel until the
Dehumidifier icon is displayed in the LCD screen (Fig B).
3) Select the desired humidity level from 35% RH ~ 80% RH
by depressing either the increase (h,.) or decrease (Y)
buttons on the control panel To select continuous
instead of defining a specific humidity level, press the
increase or decrease button untiJ the ° - - = symbol appears
in the Set humidity display portion of the LCD, as shown in
F_g.C
4) Detine the required fan speed (High/Low) by depressing
the fan speed button.
5) Activate the power button to start the unit in Dehumidifier
mode at your specified settings.
Direct drain operation Is
intended for floor drain
applications only. Direst
drain operation should not
be used tn stem pipe and/or
sink applications.
1. Remove the 'large' drain cap
on the direct drain connection,at
the bac_ of the unit, (Fig D)
2. Attach the hose and coupler
directly onto the direct drain and
hand tighten,
3. Posit_on the open end of the
drain hose directly over the floor
drain and start the unff.
4. Pesit_n the dehumdifier as dose
as yc_ can to the F, oor drain,
5. When the direct drain feature
is not in use.remove the drain
hose and re-install cap,
9