Directed Electronics Python 990 Installation Manual page 35

CHANNEL NUMBER
1
2
3
4
5
6
7
8
9
10
11
12
13
14
*NOTE: For Auto Learn Configurations, see Transmitter Configurations section of this guide.
**NOTE: If any button from a known transmitter is programmed to Channel 13, all trans-
mitters will be erased from memory and will revert to the default feature settings. This is
useful in cases where the customer's transmitters are lost or stolen.
4. Transmit. While HOLDING the Valet/Program switch, press the button on the transmitter
that you would like to control the selected receiver channel. The unit will chirp to confirm
that the code has been successfully programmed. It is not possible to teach a transmitter
button to the system more than once.
5. Release. Once the code is learned, the Valet/Program switch can be released.
You can advance from programming one channel to another by releasing the Valet/Program switch and tapping
it to advance channels and then HOLDING it. For instance: You have programmed Channel 1 and you want to
program Channel 2. Release the Valet/Program switch. Press it one time and release it to advance from Channel
1 to Channel 2. Now, press and HOLD the Valet/Program switch. The LED will flash two times and the horn will
honk twice (if connected). As before, do not release it.
If you want to program Channel 3 after programming Channel 1, release the Valet/Program switch, press it twice
and release it to advance to Channel 3. Then press it once more and HOLD it. The horn will honk three times (if
connected) and the LED will flash three times to confirm it is ready to receive the code from the transmitter.
© 2006 Directed Electronics—all rights reserved
FUNCTION
Auto Learn Standard Configuration* (default)
Arm only
Disarm only
Silent Mode™/Remote Valet/Trunk Release
Remote Start
Channel 4
Channel 5
Channel 6
Short Run/Turbo
Timer Mode
Arm/Disarm/Panic
Panic only
Defogger Control
Delete all transmitters**
WIRE COLOR
RED/WHITE
VIOLET/BLACK
WHITE/BLACK
35