Discharge Chute; Speed Selector Adjustment - Ariens 921 Series Owner's Manual

If chute does not rotate freely:
Tighten the cable by loosening the forward
adjustment nut, and then tightening the rear
adjustment nut against the bracket until all
cable slack is removed (Figure 30).
MANUAL DISCHARGE
CHUTE DEFLECTOR
(921019)
(Figure 31)
Deflector must stay in selected position while
blowing snow.
To adjust, loosen then retighten hardware to
desired deflection drag force (Figure 31).
Adjusting
Hardware
Figure 31

Discharge Chute

Deflector
Discharge
Chute
OS7176
DISCHARGE CHUTE
(921013, 019, 020, 022, 023)
(Figure 32)
If discharge chute does not stay in position
while operating, tighten nut on carriage bolt at
pivot point to increase tension on spring.
1
2
OS7177
SPEED SELECTOR
ADJUSTMENT
(Figure 33)
To adjust:
1. Disconnect adjustment pivot pin from
speed selector lever by removing
hairpin.
2. Place the speed selector on the dash in
the fastest forward speed position.
3. Turn the speed selector lever straight
down towards the ground as far as it will
go.
4. Thread the adjustment pivot pin along
the shift rod until it aligns with the mating
hole on the speed selector lever. Insert
the pivot pin into hole.
5. Secure adjustment pivot pin with hairpin.
6. Make sure the speed selector shifts into
each speed position.
7. Check forward and reverse speeds:
a. Start unit.
b. Shift speed selector into the first
forward speed.
GB - 28
2
1. Spring
2. Nut
Figure 32
1