Traveling And Transport; Maintenance - Ariens 921 Series Owner's Manual

TRAVELING
To travel from one work area to another:
1. Set Throttle to Slow or Part-Throttle
position.
2. 921013, 017, 018, 019, 020, 022: Press
down on handlebars enough to raise
front of unit slightly off surface.
921023: Place the unit in the transport
position (see Track Angle on page 20).
3. Engage wheel or track drive clutch
without engaging attachment drive
clutch.
Ariens Dealers will provide any service or
adjustments which may be required to keep
your unit operating at peak efficiency. Should
engine service be required, contact an Ariens
dealer or an authorized engine
manufacturer's service center.
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
SERVICE POSITION
WARNING: Before tipping unit up
onto housing, remove fuel so no
spills will occur . Ensure unit is
secure and will not tip over during

maintenance.

1. Shut off engine, remove key, disconnect
spark plug wire and allow unit to cool
completely.
2. Close fuel shut-off valve (see Fuel Shut-
Off Valve on page 20).
3. Drain fuel tank and fuel system (see
Engine Manual for complete
instructions).
4. Place unit on a flat level surface. Tip unit
forward onto front of auger housing for
service.
IMPORTANT: Ensure unit is secure and will
not tip over. Strap and clamp onto bench if
needed.
TRANSPORT
ALWAYS shut off engine, remove key, and
close fuel shut-off valve when transporting
unit on a truck or trailer.
Use extra care when loading or unloading
unit onto trailer or truck.
Secure unit chassis to transport vehicle.
NEVER secure from rods or linkages that
could be damaged.
DO NOT transport machine while engine is
running.
MAINTENANCE
GB - 23
Service Position
Figure 23
OS7121