Table of Contents
Advertisement
3. Return the tool to its storage position on
the auger housing.
STOP THE ENGINE
1. Release traction drive clutch lever.
2. Run auger / impeller for a few minutes to
remove loose or melting snow to prevent
impeller from freezing.
3. Release attachment clutch lever.
4. Turn engine key to stop position and
remove key.
5. Turn fuel valve to off position.
MOVE UNIT MANUALLY
See Figure 17.
To disengage transmission and move unit
with the engine off, pull the bypass rod
outward.
Push the rod in to engage the transmission
for normal operation.
Figure 17
TRANSPORT UNIT
1. Stop engine, remove key and close fuel
valve.
2. Secure unit chassis to transport vehicle.
NOTICE: NEVER secure from rods or
linkages that could be damaged.
Your Ariens dealer can provide service and
adjustments to keep your unit operating at
peak efficiency. Contact an authorized engine
manufacturer's service center for engine
service.
SERVICE POSITION
See Figure 18.
Normal
Operation
Move Unit
Manually
MAINTENANCE SCHEDULE
Service Performed
Check Clutch Lever Operation •
Check Dual Handle Interlock
Check Fasteners
Check Clutch Cable
Adjustments *
Check Tire Pressure
Check Track Tension
EN - 13
MAINTENANCE
WARNING: Read and
understand the Safety section
before proceeding.
WARNING: AVOID INJURY.
Before tipping unit, close fuel
valve and drain fuel from tank
and fuel system. (Refer to
engine manual for instructions.)
Make sure unit is secure and will
not tip.
Figure 18
•
•
•
•
•
•
Advertisement
Table of Contents
