Abit Socket 462 System Board User Manual page 46

3-4
NOTE: Some processors might have this multiplier factor locked, so there is no way to choose a higher
multiplier factor.
AGP Frequency:
This item allows you to set the AGP clock speed from 66MHz to 99MHz. Due to the AGP specification
limit, the speed you set over its standard clock speed is supported, but not guaranteed.
CPU FSB/DRAM ratio:
This item allows you to set the frequency ratio between CPU and DRAM.
CPU Interface:
Two options are available: Disabled
the system uses the most stable CPU/FSB parameters. If you choose enabled, the system will use
overclocked CPU/FSB parameters.
Power Supply Controller:
This option allows you to switch between the default and user-defined voltages. Leave this setting to
default unless the current voltage setting cannot be detected or is not correct. The option "User Define"
enables you to select the following voltages manually.
CPU Core Voltage:
This item selects the CPU core voltage.
DDR SDRAM Voltage:
This item selects the voltage for DRAM slot.
NB Core Voltage:
This item selects the NB core voltage.
AGP Voltage:
This item selects the voltage for AGP slot.
ATTENTION: A wrong voltage setting may cause the system unstable or even damage the CPU. Please
leave it to default settings unless you are fully aware of its consequences.
Press F8 to OC on the Fly:
After a new configuration on items "External Clock" and "Voltage", pressing <F8> button now in this
menu will make it become effective immediately.
ATTENTION: An external clock too much over its specification may cause the system unstable or even
fail, please proceed with highly attention.
AN7
Enabled. The default setting is Disabled. When set to Disabled,
Chapter 3