Start-Up Of Unit - Sanyo SF-L6111 Instruction Manual

INSTALLATION
Installation
1. Remove the packaging materials and tapes Remove all transportation packaging materials and
tapes. Open the doors and ventilate the unit. If the outside panels are dirty, clean them with a diluted
neutral dishwashing detergent. (Undiluted detergent can damage the plastic components. For the
dilution, refer to the instruction of the detergent.) After cleaning with the diluted detergent, always wipe
it off with a wet cloth, then wipe the panels with a dry cloth.
2. Door handle installation Remove the two plugs from the door where you will attach the door handle.
Apply door handle, plastic washer and screw and fasten the screw. For floor-level installation the handle
should be mounted at the higher location. For stacking above another compatible unit, the handle should be
mounted at the lower location.
3. Ground (earth)
~WARNING
Use a power supply outlet with ground (earth) to prevent electric shock. If the power supply outlet is not
grounded, qualified personnel must install a ground.
Never ground the unit through a gas pipe, water main, telephone line or lightning rod. Such
grounding may cause electric shock in the case of an incomplete circuit.
START-UP OF UNIT
The following procedures should be adhered to for initial start-up and continuous operation.
1. Connect the unit to dedicated power supply. Do not put any product in the unit at this time.
2. Set the desired temperature.
3. Confirm that the chamber temperature is at the desired temperature.
4. When you are satisfied that the unit is working correctly, begin slowly placing product into the chamber to
minimize the temperature rise.
5. As this freezer's shelf is also an evaporator, the surface of the shelf will reach a much colder temperature
than the displayed temperature. (The displayed temperature is the same as the air temperature inside of the
freezer). Placing heat insulation material such as plastic between shelf and product is required if the
product's desired temperature is the freezer's displayed temperature.
12
English