Installing The Option - AND CC-Link Interface AD-4402-OP-20 Instruction Manual

3.1. Installing the Option

3.1. Installing the Option
3.1. 3.1. Installing the Option Installing the Option
Caution
Remove the power cord before installing the option.
Do not install the same options.
Do not touch any inside parts within ten seconds after removing the power
cord because you may receive an electric shock.
Do not forget to tighten the screws. If a screw is not tightened, it may cause a
short circuit or an error due to noise.
Three option boards can be installed in the slots.
Initialize the RAM data in accordance with the proper procedure.
Refer to the AD-4402 instruction manual for other information.
AD-4402-20 Page 5