Setting Oven Controls - Kenmore 790.7885 Use & Care Manual

Setting Oven Controls
* Setting the Clock
. Changing between 12 or24 hour
display
Cony Cony Cony
Bake Roast Conve,t
Pre
Heat Bske Broil
Slow Warm & Flex
Cook He|d Clean
1 2 3
4 5 6
tee. Oe,o. . ,oe, ..., 7 8 9
Time Start Set/Off Miaute
Recall _ Clear
Oven
_ J_ockout
Setting the Clock
The CLOCK _'_ pad is used to set the clock. The clock may be
v
set for 12 or 24 hour time of day operation. The clock has been
preset at the factory for the 12 hour operation. When the range is
first plugged in, or when the power supply to the range has been
interrupted, the timer in the display will flash with power failure "PF"
(See Fig. 1 ).
Fig. 1
INSTRUCTIONS PRESS
To set the clock (example below for 1:30):
1. Press @. "CLO" will appear in the display (Fig. 2). @
2. Press@ @ @ pads to set the time of day to1:30 (Fig. 3). @ @ @
"CLO" will appear in the display. Press (_). "CLO" will (_
disappear and the clock will start (Fig. 4).
Changing between 12 or 24 hour time of day display:
1. Press and hold _ for 6 seconds (Fig. 3). While holding the
V
pad down the current time of day will remain and "CLO" will
disappear from the display (Fig. 4). CONTINUE holding the pad
until a beep is heard.
for 6 seconds
DISPLAY
Fig. 2
Fig. 3
2. The displaywill show either "12Ht"(Fig. 5) or "24Hr"(Fig. 6).
3. Press cloo, .... to switch between the12 and 24 hour time of day
display. The display will show either "12Hr" (Fig. 5) or "24Hr"
(Fig. 6).
4. Press _ to accept the desired change or press _ to
reject the change.
Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen,
the clock will now display time from 0:00 through 23:59 hours.
Flex
Clean
Fig. 4
Fig. 5
Fig. 6
13