Table of Contents
Advertisement
Setting Warmer Drawer Controls
•
Warmer Drawer Indicator Light
•
Removing & Replacing Warmer Drawer
Warmer
(Warm
& Ready
TM)
Drawer
Indicator
Light
(some
models)
The indicator light is located above the Warmer Drawer thermostat control. It turns on when the control is set, and stays on
until the control is turned OFF. The warmer drawer is inoperable during the Self-Clean cycle. The indicator light will not
come on during the Self-Clean cycle.
To Remove and Replace Warmer
(Warm
& Ready
TM)
Drawer
(some models)
Pull up with finger
To Remove Warmer
Drawer:
1.
_
Turn poweroff before removing the warmerdrawer.
2.
Open the drawer to the fully opened position.
3.
Locate glide lever on each side of drawer, pull up on the left glide lever and
push down on the right glide lever (See Fig.1 ).
4.
Pull the drawer away from the range.
Right Glide
Push down with finger
Fig. 1
Bearing Glide
Fig. 2
To Replace Warmer (Warm & Ready
TM)
Drawer:
1.
Pull the bearing glides to the front of the chassis glide (See Fig. 2).
2.
Align the glide on each side of the drawer with the glide slots on the range.
3.
Push the drawer into the range until levers "click" (approximately 2"). Pull
the drawer open again to seat bearing glides into position. If you do not
hear the levers "click"
or the bearing glides
do not feel seated
remove the drawer and repeat steps 1 thru 3. This will minimize
possible damage to the bearing glides.
NOTE: The Warmer Drawer wi!! NOT operate whi!e in the Se!f:Clean and i'Oven
Lockout" modes
Electrical Shock Hazard can occur and result in
serious injury or death. Disconnect appliance from electric power
before cleaning and servicing the warmer d rawer.
3O
Advertisement
Table of Contents
