Kenmore 665.1472 Series Use & Care Manual page 8

• If thecompactor cabinet faceisto beflush withthe
kitchen cabinet f ace,place retaining Bracket
mounting s crews t hrough "1."
• If thecompactor drawer f rontisto beflush withthe
kitchen cabinet f ace,place retaining Bracket
mounting s crews t hrough "3."
• If thecompactor istobemidway Between " 1"ancl
"3," place theretaining B racket mounting s crews
through "2."
""'" ° / l
"-..-" t
j
/4.Countertop
B. Retaining bracket {provided in
conversion kit)
7. Slowly lift the front slightly ancl roll compactor into the
kitchen cabinet opening.
8. Using 2 - #8 - 18 x 1/2" mounting screws (provided in
conversion kit), fasten the retaining Brackets (provided in
conversion kit) to the countertop with the mounting
screws.
Countertop mounting
A. Countertop
B. Retaining bracket {provided in conversion kit}
C. Mounting screw {provided in conversion kit}
NOTE: If retaining brackets cannot be attached to the
underside of countertop, attach mounting clips (provided
in conversion kit) to retaining brackets. Fasten compactor
to kitchen cabinet face with mounting screws through the
mounting clips.
Cabinet-face mounting
D
A. Mounting clip {provided in conversion kit)
B. Kitchen cabinet
C. Retaining bracket {provided in conversion
kit)
D. Mounting screw (provided in conversion kit)
9. Grasp sides of compactor drawer and place bottom of
drawer into tracks. Lift at the handle so drawer will go
over drawer stops. Close drawer. Check to see whether
drawer opens freely. If the toe plate rubs against floor,
see "Adjusting the Toe Plate" for further instructions.
Adjusting the Toe Plate
If the toe plate rubs the floor covering, the toe plate
clearance may be changed as follows:
1. Mark on each side of the toe plate the amount of toe
plate that rubs the floor covering.
2. Remove the drawer from the unit. See Step 3 in the
"Unpacking" section.
3. Use a ruler and a pencil or chalk to draw a line between
the marks on each side of toe plate.
4. Use scissors or utility knife to cut toe plate along line.
5. Replace drawer. If toe plate still rubs floor covering,
repeat steps 1-4.