Advertisement
Available languages
Available languages
INSTALLATION
INSTRUCTIONS
Installer:
Leave Use and Care Guide with the homeowner.
Homeowner:
Keep Use and Care Guide
for future reference
and for local electrical
inspector's use, if required.
Excessive Weight Hazard
Use two or more people to move and install compactor.
Failure to do so can result in back or other injury.
IMPORTANT:
•
Do not grasp console to move compactor.
•
Begin in the room where the compactor
will be located.
1.
Remove compactor
from shipping
carton.
Remove all
packaging
materials
such as tape and shipping pads. Use
a mild detergent
and warm
water to remove waxy
residue caused by shipping
material.
Dry thoroughly
with
a soft cloth. For more information,
see "Cleaning."
2.
Be sure the power cord is attached
to the cord clip on the
rear of the compactor.
A.
Cord
clip
.
Place the 2 corner posts from the carton on the floor near
the compactor.
Open the compactor
drawer
and remove
any shipping
materials
or other items from the drawer. Do
not remove the compactor
bag. Grasp the handle and
raise the front of drawer
until it clears the drawer
stops.
Grasp sides of drawer
and lift drawer
out of compactor.
Place the drawer
on the 2 corner posts.
4.
Place the other 2 corner posts on the floor to the side of
the compactor.
Grasp the sides of the compactor
cabinet
and put compactor
on its side on top of the corner posts.
Remove the shipping
base from the bottom
of the
compactor.
B
A. Leve/ing
/egs
B. Shipping
base
Advertisement
