Adjusting Burner Flames; Installation Instructions For Lp - GE Monogram ZGU384N Installation Instructions Manual

Installation Instructions for Natural to LP Gas Conversion
CHANGE BURNER ORIFICES (cont.}
IMPORTANT: O rificesmust be located exactlg as shown
Carefullg read and observe each orifice label for correct
location.
ORIFICES
0
0
0 0
All Other
Burners
LP Nat _1
MAIN
ORIFICES
0
0
C. Install the proper orifices in the exact locations as noted
in the illustrations above.
D. Return the natural gas orificesto the bracket and
reattach the bracket and the instruction sheet to the
pressure regulator using the screw removed previouslU.
E. Replacethe burner bases, heads,caps and top grates,
ADJUST BURNER FLAMES
A. Turn all burners on highest setting and check the flames.
Theu should be blue in color and mau have some yellow
tipping at the ends of the flame when using LPgas.
Foreign particles in the gas line maU cause an orange
flame at first, but this will soon disappear.
8. Turn the cooktop burner knob to "LO"while observing
the flame,
Adjust the setting of the upper row of flames using the
valve bgpass screw as follows:
Adjustments must be made with two other burners in
operation on a medium setting. This prevents the upper row
of flames from being set too low, resulting in the flame
being extinguished when other burners are turned on.
C. To adjust the flame, remove the knobs.Inserta screwdriver
through the access hole in valve shaft as shown.
16
• If the flames were too small or fluttered, open the valve
more than the original setting.
If the flames blew awa Ufrom the burner, close the valve
more than the original setting.
D. Make the adjustment bg slowlu turning the screw until
flame appearance is correct.
E. Testing Flame Stabilitg:
Test 1 - Turn the knob from "HI" to "LO"quicklU.
If the upper row of flames goes out at this setting,
increase the flame sizeand test again.
Test 2 - With the burner on "LO',open and close the
cabinet door under the cooktop. If the flame is
extinguished by the air currents created bg the
door movement, increase the flame height and
test again.
NOTE:When the burner is on the "SIN"setting, the upper
row of flames will go out.
F. Flame Recheck:
After the adjustment is made, turn all burners off. Ignite
each burner individuallU.Observethe flame at the "HI"
position. Rotate the knob to the lowest setting and be
sure that the flame size decreases as the knob is
rotated counterclockwise.
Once the conversion is complete and checked ok,
fill out the conversion sticker and include your name,
organization and date conversion was made. Applg
the sticker near the cooktop gas inlet opening to
alert others in the future that this appliance has been
converted. If converting back to the original gas, please
remove the sticker so others know the appliance is set
to use its original gas.